A10 Pro is an INNOSILICON mining machine that uses Ethash algorithm for ETH mining. The official calculation power is 500MH/s (± 5%), and the wall power consumption is 860W (+/ -10%).
Data shows that Ethereum DAG files are growing by 520M per year, with the current Ethereum DAG file at 3.728GB and the Ethereum Classic at 3.82G. According to this calculation, the DAG file will reach 4G by the end of December 2020. Existing 4G graphics cards can no longer be mined. The A10 Pro is an updated version of INNOSILICON A10, with improved computing power and upgraded system memory to 5G.
A10 Pro mining machine is designed as a single cylinder. Two parallel fans are used to provide heat dissipation for the calculation plate. The calculation plate and the control board are connected by row wires.
G5118-1400w power supply has 10 6Pin power connectors for connecting with mining machine power plate and control board. Meanwhile, this power supply can be adapted to Innosilicon A9 / D9 / A8 / A5 / A4 + series mining machine.
It is natural to lay flat, but it should be noted that the outlet of the power supply is located at the interface of the AC power cable. If the outlet position is not adjusted during mining, it may lead to thermal backflow (the power supply will pump the hot air from the outlet side of the mining machine back to the inlet of the mining machine).
Enter the IP address in the browser to access the A10 Pro login page. The default login account and password are admin.
On the Overview page, view system information about the A10 Pro. If Type is A10L, the A10 Pro 5G video memory version is displayed. You can view the firmware version of the A10 Pro.
The air outlet temperature of the ore machine was 34.9 degrees when the room temperature was 25.8 degrees.
The average calculating force of bTC.com mine pool receiving in 24 hours is 503.2m, which is in line with the manufacturer's nominal parameters. The calculating force receiving will have a little fluctuation, and the rejection rate will also fluctuate with it.