The Blackminer F2 is a FPGA mining machine (a high-performance, multi-algorithm mining machine) that supports multiple mining algorithms and can switch between mining machine algorithms.

Blackminer has recently introduced an upgraded version of the Blackminer F2 that is more robust, efficient and stable.

The Blackminer F2 is a FPGA mining machine (a high-performance, multi-algorithm mining machine) that supports multiple mining algorithms and can switch between mining machine algorithms.

The Blackminer F2 contains two power plates that upgrade the hardware design and product architecture of Blackminer's previous product line.

The Blackminer F2 continues the robust performance of the Blackminer F1-Ultra, with structural improvements that provide more reasonable stress and heat dissipation, longer life, and a transport failure rate of only 0.1% to 0.2%. Aiming at the new core chip, some algorithms are optimized and improved.

Today xiaobian will give you a review of the F2 mining machine:

Let's take a look at the parameters of F2 from the official website:

The outer package of express delivery adopts two-layer industrial carton, the two ends of the mining machine are wrapped with pearl cotton board to enhance the shock absorption effect, and the pearl cotton board is attached to the mining machine and the carton to tightly protect the mining machine from damage in the process of transportation.

F2 bare size 360mm X 140mm X 200mm The same size as F1-U.

The figure below shows the front, side, back and top of the miner. It can be seen that the F2 miner has the same appearance as the miner before BlackMiner.

The mining machine has two power plates, each of which has three 6PIN power interfaces. Plus the control board power supply, there are seven 6PIN power interfaces in total.

One fan at the front and one at the back.